• Apple iPhone 6 - 514668 Holder for Cable Attachment

Apple iPhone 6 - 514668 Holder for Cable Attachment

  • Brodit
  • 514668
  • In Stock
  • £49.95

Brodit Holder for Cable Attachment

Holder with connector attachment. The choice for you who often connect a connector to your device. The connector is easy to attach to the holder, and then it connects to the device automatically when you put your device in the holder so you do not have to connect it manually each time. (Connector not included)  

Check the compatibility section if supported with your mobile phone

Only for the new Griffin PowerJolt cable without release buttons on the side.  

Compare the connector in the picture with the connector on your cable in order to find the correct holder. The holder is attached onto a tilt swivel, so it can be adjusted in order to avoid light reflection on the screen. Attach onto a ProClip Mounting Platform.

*Requires a ProClip mounting bracket or similar product to secure the holder without damaging the dashboard. Visit the fitting accessories section and you will find different options to suit your requirements.

Whats Included?

  • Brodit Holder (mounting bracket sold seperately)*
  • Fitting Instructions
some Brodit accessories are dispatched direct from our suppliers as they are special order. If the item is not in-stock in the UK with our supplier it may have a lead time of 5-7 working days for delivery. Please check with us before ordering Brodit items.

 

The holder fits for iPhone 6 without skin and without Apple original Bumper

Installation is easy, with no special tools required. Detailed instructions with pictures are included. Please read all of the instructions and look at the pictures before attaching the holder. Full Instructions also come with your Brodit holder.

*Requires a ProClip mounting bracket or similar product to secure the holder without damaging the dashboard. Visit the fitting accessories section and you will find different options to suit your requirements.

1.
2.
3.
4.

1. Place the connector of the cable in the hole in the lower part of the holder. Carefully press the connector downward and forward so it passes the locking and goes into the hole. Press until you hear/feel the connector snap into place in the holder.

2. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.

3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.

4. The holder is in place.


Dash Holder Spec
Holder Features Holder for Cable Attachment

Write a review

Note: HTML is not translated!
    Bad           Good