Apple iPhone 6 - 515662 Holder for Cable Attachment
- In Stock
Brodit Holder for Cable Attachment
Holder with connector attachment. The choice for you who often connect a connector to your device. The connector is easy to attach to the holder, and then it connects to the device automatically when you put your device in the holder so you do not have to connect it manually each time. (Connector not included)
Check the compatibility section if supported with your mobile phone
Only for the new Griffin PowerJolt cable without release buttons on the side.
Compare the connector in the picture with the connector on your cable in order to find the correct holder. The holder is attached onto a tilt swivel, so it can be adjusted in order to avoid light reflection on the screen. Attach onto a ProClip Mounting Platform.
*Requires a ProClip mounting bracket or similar product to secure the holder without damaging the dashboard. Visit the fitting accessories section and you will find different options to suit your requirements.
- Brodit Holder (mounting bracket sold seperately)*
- Fitting Instructions
|some Brodit accessories are dispatched direct from our suppliers as they are special order. If the item is not in-stock in the UK with our supplier it may have a lead time of 5-7 working days for delivery. Please check with us before ordering Brodit items.|
The holder fits for iPhone 6 without skin and without Apple original Bumper
Installation is easy, with no special tools required. Detailed instructions with pictures are included. Please read all of the instructions and look at the pictures before attaching the holder. Full Instructions also come with your Brodit holder.
1. Place the connector of the cable in the hole in the lower part of the ProClip. Carefully press the connector downward and forward so it passes the locking and goes into the hole. Press until you hear/feel the connector snap into place in the holder. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
3. To place the device in the holder: Place the upper part of the device in the upper part of the holder and press it upward so the top part of the holder slides upward. Press the lower part of the device forward into the holder. When the device is placed straight over the connector in the holder, take the device straight downward so the connector is connected. Carefully, press striaght downward on top of the device until you hear/feel it snaps into place. To remove the device from the holder: Press the device straight upward so the top part of the holder slides upward. When the device is set free from the connector, pull the lower part of the device toward you and slide the device downward out of the holder.
4. The holder is in place.
|Dash Holder Spec|
|Holder Features||Holder for Cable Attachment|